泽宁特+mp5？！ 自建模3d打印
入了3d打印机有段时间了自己瞎整疼了三个建模版本https://mag1.sdgun.net/public/emotion/face_038.png
加上边调试机子和切片https://mag1.sdgun.net/public/emotion/face_038.png
终于完成了还可以用的mp5泽宁特鱼骨图纸
适配锦明二代的
豪赌了一把直接拉到80%填充https://mag1.sdgun.net/public/emotion/face_033.png
幸好今早打出来完美适配https://mag1.sdgun.net/public/emotion/face_061.pnghttps://mag1.sdgun.net/public/emotion/face_068.png
但是打印效果还是不咋滴
pla材质，喷嘴215℃，热床55℃
不够光滑，轻微拉丝，之前拉丝更恐怖
（自己测绘真累⊙﹏⊙）
http://picapp.sdgun.net/pic/20240906/1725591893383969_851.png
http://picapp.sdgun.net/pic/20240906/1725591909741396_953.jpg
http://picapp.sdgun.net/pic/20240906/1725591910075768_837.jpg
http://picapp.sdgun.net/pic/20240906/1725591910279659_960.jpg
http://picapp.sdgun.net/pic/20240906/172559191047890_881.jpg
http://picapp.sdgun.net/pic/20240906/1725591910694310_75.jpg
http://picapp.sdgun.net/pic/20240906/1725591910883894_416.jpg
http://picapp.sdgun.net/pic/20240906/172559191108957_340.jpg
这是之前的两个版本
填充只有20%都裂了……
http://picapp.sdgun.net/pic/20240906/1725591976304307_876.jpg
切片搞来搞去感觉斜着的效果最好
有没有佬分享一下经验https://mag1.sdgun.net/public/emotion/face_076.png
http://picapp.sdgun.net/pic/20240906/1725591992741352_276.jpg
http://picapp.sdgun.net/pic/20240906/1725591992947547_215.jpg
http://picapp.sdgun.net/pic/20240906/1725591993205564_482.jpg
http://picapp.sdgun.net/pic/20240906/172559199347042_875.jpg
http://picapp.sdgun.net/video/20240906/1725591997005445_703.mp4
好看 如果能做到三面导轨就完美了 泽宁特连夜开启mp5市场x
页:
[1]