jellyfffish 发表于 2024-11-13 16:37:19

适配老学校m4的圆筒护木导轨

本帖最后由 jellyfffish 于 2024-11-16 15:33 编辑

前因是因为cod21里面的xm4,圆筒护木加装导轨片再加装前握把的造型,非常让人眼前一亮,于是乎就有了还原这一造型的想法https://mag1.sdgun.net/public/emotion/face_wangchai.png
http://picapp.sdgun.net/pic/20241116/1731741440954103_63.png
经过粗略测量,我手头的圆筒护木孔直径约1cm,深度大概8到9毫米https://mag1.sdgun.net/public/emotion/face_zhoumei.png
适配导轨的关键在于这个m5型号的螺母长度大于一公分,可以卡在护木内侧,并且螺丝长度大于护木孔深度https://mag1.sdgun.net/public/emotion/face_kankan.png
经过实测,装上导轨拧紧螺丝后,长出螺母末端的螺丝不会剐蹭到内管https://mag1.sdgun.net/public/emotion/face_tanqi.png
商家名字就不细说了,某宝搜圆筒护木导轨即可
http://picapp.sdgun.net/pic/20241116/1731741217044432_861.png
http://picapp.sdgun.net/pic/20241116/1731741604583469_418.jpg
http://picapp.sdgun.net/pic/20241116/1731741604587890_158.jpg
http://picapp.sdgun.net/pic/20241116/1731741604589155_538.jpg
最后是装上导轨后的m4以及装上前的造型对比https://mag1.sdgun.net/public/emotion/face_wangchai.png握把是便宜的尼龙料骑士握,镜子是便宜义乌购m2红点
http://picapp.sdgun.net/pic/20241116/1731741744681239_348.png
http://picapp.sdgun.net/pic/20241116/1731741757567128_959.jpg
http://picapp.sdgun.net/pic/20241116/1731741789805400_891.png
http://picapp.sdgun.net/pic/20241116/1731741884758879_998.jpg

jellyfffish 发表于 2024-11-13 19:34:33

附一张cod21的图图https://mag1.sdgun.net/public/emotion/face_zhoumei.png
http://picapp.sdgun.net/pic/20241113/1731497584409970_92.png

jellyfffish 发表于 2024-11-14 12:31:24

自顶
页: [1]
查看完整版本: 适配老学校m4的圆筒护木导轨